Bridge Or Bridge Extension For Picking Hand Support

author: Steven Bayes date: 03/14/2013 category: music theory
I like this
12
voted: 3
Bridge Or Bridge Extension For Picking Hand Support

Abstract

The correct way to pick is by no support of the picking hand. This, if mastered, provides for the fastest picking ability. However, to achieve a high level, high accuracy picking without hitting a wrong string is rather difficult, yet, on occasion, a must. This is why a lot of guitar players use their tiny finger to support their picking hand to the guitar body of, usually, an electric guitar or at the hum bucker. With acoustic guitars, this support may reduce tonal quality, although so extremely insignificant, there is no need to even talk of this. Other players support their picking hand on the bridge. The two techniques limit the speed and movement of the picking hand gaining accuracy. The bridge supporting hand limits the range of picking in the direction of the neck thus bringing higher pitch tones when hit near the bridge but providing for a higher mechanical stability of the strings near the bridge thus an easier fast picking or tremolo picking. A proposal for a "support device" is made here. (Not to be mistaken with a hokey players' supporter.)

Introduction

A metallic, plastic, strong rubber, wooden or made out of any appropriate material bridge extension or a new bridge alike structure can be positioned over the strings at any picking place along the guitar body. The tremolo bar can also be used, better, with some kind of supporting piece to avoid the possibility to be accidentally pressed.

Solution

The new bridge or bridge extension would have a shape similar to the character of the Greek alphabet pi with the posts resting on the guitar body and the bar going over the strings. This can be secured with a double sided sticky tape or removable or silicon glue or can be permanently screwed to the guitar body. There may be an insignificant reduction in sound quality, most likely, not detectable at all. A better way may ne to bolt a plate onto the guitar bridge and position the plate in the direction of the strings towards the neck. The length depends on where the player want to hit the strings. Without any special cutouts, though, this may prevent the player to be able to hit the strings near the bridge. The existing tremolo bar can also be used in, for example, this way. Position the bar over the strings at a desired angle between the strings and the bar. Use some kinda piece, best out of strong rubber, to support the bar in such a way as not to be able to be pressed down and, thus, to release the strings (as tremolo bars normally do). One may wish to disable this movement at the tremolo bar mechanism as well. One can either use the tremolo bar as a supporter just as is but must be careful not to press.

Summary

An improvement to the picking hand support has been made. By Steven Stanley Bayes
More Steven Bayes columns:
+ String Lock With Gibson Bridge and Individual String Height Adjustment Gear Maintenance 11/11/2013
+ A Tuning Machine for Each String (or Each Type) Gear Maintenance 10/08/2013
+ Hand-Crafted Guitars and Drums General Music 09/11/2013
+ The Importance of Guitar Lacquer Paint and Plastics & Metals General Music 09/10/2013
+ How to Adjust Truss Rod General Music 09/04/2013
+ Holding the Pick The Guide To 04/03/2013
+ view all
Comments
Your captcha is incorrect