UG Community @ Ultimate-Guitar.Com

UG Community @ Ultimate-Guitar.Com (http://www.ultimate-guitar.com/forum/index.php)
-   Gear Building & Customizing (http://www.ultimate-guitar.com/forum/forumdisplay.php?f=53)
-   -   SG Wiring Issue (http://www.ultimate-guitar.com/forum/showthread.php?t=1565962)

makutoid 10-02-2012 04:00 PM

SG Wiring Issue
 
I have an Epiphone SG (G400), which had possibly the crappest sounding stock pickups I've ever heard. I had some old pickups from a 1970s Les Paul copy that I took out cause they weren't potted, so I potted these and went to install them in the SG. Here's the problem...

The stock pickups not only sucked, but the bridge pickup hasn't worked for several years - I assumed from when I was a kid and pulled a screw out of it, put it back in, and it hadn't worked since. Very low signal but it is present.. When I put the new pickups in, it's doing the same thing again?

I know that both the new pickups work as there were no problems (other than feedback) when they were in the original guitar, and it's not the switch as I reversed the wiring and it did the same thing but obviously reversed.. I also replaced the volume pot on the bridge pickup and that didn't do it either.

ANY IDEAS?! I love this guitar and would love to have it working, and these old pickups are pretty sweet too. Please help!


All times are GMT -4. The time now is 05:53 AM.

Powered by: vBulletin Version 3.0.9
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.