Go Back   UG Community @ Ultimate-Guitar.Com > Instruments > Bass Guitar
User Name  

Old 02-14-2013, 04:38 PM   #1
food1010's Avatar
Join Date: Jun 2007
Problem with string snapping by the nut

So I recently came across a precision-style bass (not sure who built it) that was missing a nut. I bought a nut and sanded it down and installed it.

The issue I'm having isn't with the nut though, it's with the little round part on the headstock that adds tension to the top two strings. Not sure what the part is called, so here's a picture:


The groove on the bottom of that round piece that's supposed to fit the 2nd string is too narrow for the string. I'm using D'addario .045-.100 strings (the 2nd string is .065).

The problem I'm having is that these strings are wound narrower near the end (to make it easier to tune, I'm presuming). Whenever I'm putting the string on and winding it up, the spot where the string starts being wound at its full width hits that little notch. The pressure makes the string core snap and it just unwinds.

Now I only tried it once, but I don't want to waste a whole other pack of strings considering I know the same thing will happen again, and bass strings are expensive.

So what I want to know is, should I just get a replacement for that circular part that would fit the string better? Or should I buy a different type of strings that is wound at the same width all the way up the string? Or do you think I need to just be more careful with how I string the bass?

If you think this belongs in GB&C, I can delete this one and move it over there.
Only play what you hear. If you donít hear anything, donít play anything.
-Chick Corea
food1010 is offline   Reply With Quote
Old 02-14-2013, 04:46 PM   #2
dark Mass
dark Mass's Avatar
Join Date: Oct 2009
Location: I Don't Care
It's called a string retainer.
Damn it! Disable can't use disable to disable Disable's disable because disable's disable has already been disabled by Disable's disable!
dark Mass is offline   Reply With Quote
Old 02-14-2013, 06:25 PM   #3
UG's only DB
Deliriumbassist's Avatar
Join Date: Apr 2006
Location: Presidential Palace
Tighten the string without putting it under the retainer until it is just loose enough to slide it into the retainer grooves. By then, the beginning of the wind should be past the retainer. And don't forger to cut your strings down to about 10-13cm past the relevant post.

Deliriumbassist is offline   Reply With Quote
Old 02-14-2013, 07:04 PM   #4
War Mastiff!!!
FatalGear41's Avatar
Join Date: Oct 2009
Location: Planet 10 / The 8th Dimension!
A bar string retainer will solve your problem, too. They cost about $4.00 and they require drilling two little holes for the screws. Any good repair tech can do it for you in five minutes.
"Drinking is a skill and should be recognized as such!"

Originally Posted by gregs1020
FatalGear41 knows the ways of the obscure. I hear it's just not with Gibsons. Beware, Halloween approaches...

Originally Posted by Spaz91
FatalGear41 is offline   Reply With Quote

Thread Tools Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT -4. The time now is 07:15 AM.

Forum Archives / About / TOS / Advertise with us / Customer Support / Ultimate-Guitar.Com © 2015
Powered by: vBulletin Version 3.0.9
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.