Zeta11

Okay so I have a problem here, I have a fuzz factory and a Boss Me-50. the problem is that I want to activate my fuzz and the distortion section from the boss by only using one footswitch. Is it possible?
Thanks in advance for answering to my question!

kolenik

Put them in a looper. Have both of them on, activate them with a switch on your looper.

gumbilicious

it's not directly possible, but it is indirectly possible.

they have certain devices that act as a series of effects loops. you put pedals in each loop and you can include them or exclude them from your signal chain. if you put the ME50 and the fuzz factory in a single loop together then you can bypass both at the same time.

these effects loop pedals can get very sophisticated too, some are able to be programmed so that you have one click access to any arrangement of loops in any order.

__________________
"A perfection of means, and confusion of aims, seems to be our main problem."
-ae

Zeta11

So, I put ON the fuzz and the OD of the boss and I could activate both with the looper?

kolenik

Yeah, you keep them both on. The looper on OFF bypasses them, on ON, the signals from both are included in the signal path. The loopers are pretty cheap and also easy to DIY.

Zeta11

Great, thank you very much, I'll try it!

Danjo's Guitar

Or you could put a board across both pedals so you just step on the board and it activates both. Just kidding, but thats totally how I would ghetto rig it if I was in a pinch. Or if I was still in highschool, I did some crazy stuff with my gear sometimes. The looper should be good.

__________________


RIP airbrendie Grammy's tickets thread

Officially beautiful http://www.ultimate-guitar.com/foru...358&postcount=1

If you are reading this you might need to chill out.