|11-24-2012, 08:57 PM||#1|
Join Date: Dec 2010
Jack port loose on Riviera!!
The jack port on my Epi Riviera (hollowbody) is loose... But unlike a Les Paul there is no access to repair it!
The f-holes are too small... how can I fix it ??
|11-24-2012, 09:54 PM||#2|
Join Date: Dec 2009
The nuts in the outside right. You just need a locking spanner for the nut
buffalo buffalo buffalo buffalo buffalo buffalo buffalo.
|11-24-2012, 10:39 PM||#3|
Grumpy Old Tech
Join Date: Oct 2009
You can make something similar yourself with an allen bolt a piece of surgical rubber tubing and a couple of nuts. The bolt has to fit in the hole, tubing that just fits snugly in the hole around the bolt. Then screw down the nut to distort the tubing, then use the second nut as a locking nut to hold it all in place and give you something to hold onto with a spanner/socket. You'll probably need a washer between the head of the bolt and the tubing depending on the bolt you use.
I've also done it using a pair of needle nose pliers pushed into the hole and pulled open to grab the jack while you tighten the nut on the jack. I had a pair that I ground the back of the jaws flat so there was a corner to bite into the inside of the jack. That worked too.
You could also modify a pair of outer circlip pliers the same way so you squeeze to hold the jack still rather than trying to pull the handles apart like you have to with pliers. Some circlip pliers already have corners on the jaws so no modification is even needed.
Gilchrist custom guitar
Abbey Harmonic II
Marshall JTM45 clone
Marshall JCM900 4102 (modded)
Marshall 18W clone
Fender 5F1 Champ clone
Last edited by Cathbard : 11-24-2012 at 10:49 PM.
|Thread Tools||Rate This Thread|