#1
Hi, this is my first post and wasn't too sure if this should be under the gear section or the electric guitar section sorry. I checked both but neither had anything too similar to this.

I'm using an Ibanez RG350DX with an Edge Zero-III trem, and recently noticed if I do quite large string bends while playing a note on a different string as well, that the bridge pulls forward (as if I was pushing down slightly on the trem) causing notes to go flat. I'm just wondering, is there any way to prevent this from happening?

Again, apologies if I'm in the wrong section.
Thanks
Sam
#2
Yeah, that's gonna happen with pretty much any floating trem. Any time you bend a note, it'll affect the pitch of the other strings. If you want to keep using the trem, you have to learn to compensate for it by slightly bending the "non-bent" note. With this in mind, you'll get used to it; it sounds a lot harder than it is. The most important thing is to use your ear and it'll become second nature.
#3
If you have the edge zero-II bridge with the ZPS enabled, you shouldn't really notice the strings going flat unless you're doing extreme bends. Or at least that's my experience with the edge zero + zps in my rg3570.
Fleet of MiJ Ibanez
Couple of Balls
Peavey & EVH Wolfgangs
Eclipse
Fender HM Strat
Kemper KPA
5150 III 50w & cabs