#1
How would I run this in stereo? I can't figure it out.

Engl Preamp (1 fx loop out, 2 fx loop ins (l&r), 2 line outs (l&r)
Behringer EQ (2 channels, both with 1 line I/O
TCE, L&R I/O
Carvin TS 100, 2 channel imputs, 2 channel outputs.

Do I just rewire the rig with stereo cables, and then run 2 monos from both line outs into the channel 1 and channel 2 of the power amp?
Baron K2 SE 120
MILLS 4x12 Afterburner
Eventide TimeFactor Delays
ISP Pro Rack G Noise Suppressor
BKP Warpig pickups
Last edited by kayman121 at Nov 20, 2008,
#3
No Decimator?

Well if so..

Guitar into channel 1 of decimator
Out of channel 1 into preamp input
FX loop send to input of EQ (Channel 1)
Out of channel 1 to input of decimator channel 2
Out of that to one input of g major (most likely left is best)
Right output to right fx return, left to left return
Right preamp out to right poweramp in, and left to left.
Poweramp outs to seperate cabs (or a stereo cab)

That's how I'd do it

Use all mono cables.
These go to eleven...
Last edited by JimPlaysGuitar at Nov 20, 2008,
#4
Quote by JimPlaysGuitar
No Decimator?

Well if so..

Guitar into channel 1 of decimator
Out of channel 1 into preamp input
FX loop send to input of EQ (Channel 1)
Out of channel 1 to input of decimator channel 2
Out of that to one input of g major (most likely left is best)
Right output to right fx return, left to left return
Right preamp out to right poweramp in, and left to left.
Poweramp outs to seperate cabs (or a stereo cab)

That's how I'd do it

Use all mono cables.


I'm using the decimator, but I dont think I need the stereo mod because it's just a single fx loop. It's first in my chain
Baron K2 SE 120
MILLS 4x12 Afterburner
Eventide TimeFactor Delays
ISP Pro Rack G Noise Suppressor
BKP Warpig pickups
#5
Quote by kayman121
I'm using the decimator, but I dont think I need the stereo mod because it's just a single fx loop. It's first in my chain
It's not really stereo, it just provides noise cancellation pre AND post preamp.
These go to eleven...