#1
Ok guys, I added a a jack for a 9 volt AC adapter in my Russian Big Muff Pi and it works, there's just a loud hum when i use it.

I was looking in anoeth EHX pedal i have and there are two ground wires coming from the jack. One goes to the PCB and the other goes to the switch. I have the wire going to the PCB, so I just need to know where to solder the wire to the switch.

Or, If im wrong please correct me.

Any diagrams/criticism/etc. is appreciated.
Quote by asfastasdark
+1. This man knows his ****.


Walker Rose.
#2
In Russian..Big Muff Grounds YOU

i have the same problem with my pi. im gonna sell it to unsuspecting ebayer anyway and get a fuzzface
#3
good one, I should have saw that coming!
Quote by asfastasdark
+1. This man knows his ****.


Walker Rose.
#4
Quote by Mezzo4te
In Russian..Big Muff Grounds YOU

i have the same problem with my pi. im gonna sell it to unsuspecting ebayer anyway and get a fuzzface


Scumbag
#6
I don't know for sure, im just going off of some advice I got here, and from looking in another EHX pedal.
Quote by asfastasdark
+1. This man knows his ****.


Walker Rose.
#7
Ok, ill try it with a different power supply!

Also, ill probably have pictures later today/tommorow, depending on thanksgiving plans.
Quote by asfastasdark
+1. This man knows his ****.


Walker Rose.