#1
I have a Marshall JCM2000 DSL401 and I turned it on today and there was no sound. I look around back of the amp and the tubes did not light up when I turned it on. I replaced the preamp tubes and the power tubes but still the same story. The fuses look fine, i think. If anyone could advise me if they have a similar situation or any suggestions before I take it to a repair shop ,It would be greatly appreciated...Thanks ahead.
#2
If you don't know how check fuse to be certain it is fine, replace it with correct replacement.
#3
Would a fuse cause none of the tubes to light up? Because it powers on, but the tubes are not lit up...?
#4
If the HT fuse blew it would. Replace that and see if that doesn't solve your problem.
I don't give a shit if you listen to me or not