#1
if i change 009- 042 to 010-052 will i have to adjust truss rod?

im really bothered the neck will snap its a fixed bridge

if so, how would i do this?


Thanks
#2
I went from 9's to 11's. It didn't kill the neck, but the action is definitely higher when in standard tuning. I was hoping to cut a few corners and be able to do everything from drop b to standard with 1 guitar, but I'm going to have to do a few.

If your going to the 10's and dropping it half a step, you'll be fine I believe.
#4
If you have any kind of trem system it will mess it up. on my RG120 It almost pulled the trem system out. If you have to adjustthe truss rod you would have to go into the body of the guitar and adjust the claw. But if you dont have a trem im not sure what it'll do.
Needs a new sig

Scandanavian Metal > American Thrash/Groove> Everything Else

Gear:
Jackson JS32T Kelly
Ibanez RG120
RavenRG60
Boss Metal Zone
#5
Quote by COBHC145
If you have any kind of trem system it will mess it up. on my RG120 It almost pulled the trem system out. If you have to adjustthe truss rod you would have to go into the body of the guitar and adjust the claw. But if you dont have a trem im not sure what it'll do.

.......Don't pay attention to him.


I would recommend adjusting it but it is not required
My Gear :
LTD Fx400
Ibanez S470dxqm w/Tone Zone
Buz Mcgrath's S7320 w/ emg 707s
Boss Gt-8
EHX Metal Muff with top boost for sale!
Crate V32 palomino for sale !
#6
Thanks for help everyone

at least now i have someone to blame when everything explodes