#1
My bridge humbucker cavity was made too deep it goes through to the back trem cavity. Can this be a problem?

Also, I a bit worry that I might have put my springs the wrong way. They aren't suppose to look like that, are they?

Here's the picture
G͔͓̅e͎͉̟̽ͬ͐̎̃͐ͨͅå͈͖͕̹̤̟̐̏͋ͅr̩͕̫̰̗s̹̳̼ͥ̒̍̄̅ͥ̚:


ESP Standard Eclipse I CTM VW
ESP LTD Deluxe H-1001
ESP LTD Deluxe Viper-1000 STBC
ESP Edwards E-EX-100STD
Warmoth Paulcaster "Tiger"
Tanglewood TW170 AS
Vox Tonelab ST
Blackstar HT-1R


#2
I cant see your picture.... try posting it again... as for the cavity problem... It may take a bit away from your sound... and give a slightly hollowbody sound..... but I really doubt that... how bad is the hole?

[EDIT]

ok now that I see the picture... your springs look ok... and that small hole shouldnt be a problem... though if it becomes one you could just cover it over with a small piece of thin wood and glue
Total Failure

If every dream is a wish, then to dream of zombies is to wish for an appetite without responsibility
#3
It works now... for some reason it wouldnt load when I first viewed this page
Total Failure

If every dream is a wish, then to dream of zombies is to wish for an appetite without responsibility
#4
I think put a thin piece of wood with glue in there would be quite a good idea.
I might accidentally make the hole bigger when adjusting the springs otherwise.
G͔͓̅e͎͉̟̽ͬ͐̎̃͐ͨͅå͈͖͕̹̤̟̐̏͋ͅr̩͕̫̰̗s̹̳̼ͥ̒̍̄̅ͥ̚:


ESP Standard Eclipse I CTM VW
ESP LTD Deluxe H-1001
ESP LTD Deluxe Viper-1000 STBC
ESP Edwards E-EX-100STD
Warmoth Paulcaster "Tiger"
Tanglewood TW170 AS
Vox Tonelab ST
Blackstar HT-1R


#5
From the picture it looks like your trem claw is raising off the body which isnt good
Ibanez RG7321
Jackson Randy Rhoads V with Floyd Rose
Peavey Valveking 112
Digitech RP70 Guitar Processor
#6
Quote by Lethal Dosage
From the picture it looks like your trem claw is raising off the body which isnt good


What can I do to fix this?
G͔͓̅e͎͉̟̽ͬ͐̎̃͐ͨͅå͈͖͕̹̤̟̐̏͋ͅr̩͕̫̰̗s̹̳̼ͥ̒̍̄̅ͥ̚:


ESP Standard Eclipse I CTM VW
ESP LTD Deluxe H-1001
ESP LTD Deluxe Viper-1000 STBC
ESP Edwards E-EX-100STD
Warmoth Paulcaster "Tiger"
Tanglewood TW170 AS
Vox Tonelab ST
Blackstar HT-1R


#7
Quote by hminh87
What can I do to fix this?


Personally I would say just loosen it up and remove the trem then put it back in, honestly if your not confident you can do it take it to a shop. Im just afraid that with the claw at that angle the springs are eventually gonna come off.

EDIT: If I am wrong about this somebody please correct me
Ibanez RG7321
Jackson Randy Rhoads V with Floyd Rose
Peavey Valveking 112
Digitech RP70 Guitar Processor
Last edited by Lethal Dosage at Dec 11, 2008,