#1
I wasn't quite sure where to put this thread, but here it goes.

I'm putting a new black Graph Tech nut on my PRS SE Semi-Hollowbody.

Problem is, they don't make one that is exactly the right dimensions.

Should I get one that a bit too tall, or one that's a bit too short?

The measurements for the nut is:

Height: 6mm (at smallest point, toward the peghead) and 7.5mm (closer to the neck)
Length: 45mm
Width: 6mm
E-e: 35mm

Here's the link to the Graph Tech site.
Last edited by Mitchell? at Dec 23, 2008,
#4
Quote by Mitchell?
I wasn't quite sure where to put this thread, but here it goes.

I'm putting a new black Graph Tech nut on my PRS SE Semi-Hollowbody.

Problem is, they don't make one that is exactly the right dimensions.

Should I get one that a bit too tall, or one that's a bit too short?

The measurements for the nut is:

Height: 6mm (at smallest point, toward the peghead) and 7.5mm (closer to the neck)
Length: 45mm
Width: 6mm
E-e: 35mm

Here's the http://www.graphtech.com/products.html?CategoryID=5 to the Graph Tech site.



Get the short one, raise it a bit with a shim or two made from card. Don't bother gluing the nut in, the strings will hold it down.
#5
way to go, two idiots (not mini brown) above me. i wish this subforum was watched over better for stupid **** like that


get it too tall, so you can sand it down to exactly what you need
Official Aspie member

ANOUNCEMENT: Weird misspellings or words that make no sense? there was a good chance this was sent from my Droid 2 phone.
Quote by SinisterStrieth
.. You are the man.

RIP Dime RIP Michael Jackson
#6
Could you not just get the taller one and file the bottom down?

btw I think you got your text and http link the wrong way round

EDIT: damn beaten to it while I checked out the site
#7
Quote by bellerophon
Could you not just get the taller one and file the bottom down?

btw I think you got your text and http link the wrong way round

EDIT: damn beaten to it while I checked out the site


ha, i noticed that, i loled pretty hard

remember, its way easier to take off material than add it back
Official Aspie member

ANOUNCEMENT: Weird misspellings or words that make no sense? there was a good chance this was sent from my Droid 2 phone.
Quote by SinisterStrieth
.. You are the man.

RIP Dime RIP Michael Jackson
#8
Quote by conor1148
way to go, two idiots (not mini brown) above me. i wish this subforum was watched over better for stupid **** like that


get it too tall, so you can sand it down to exactly what you need



Someone needs to take one of the old chill pills...
#9
Quote by the--trooper
Someone needs to take one of the old chill pills...


go get raped, i come here to stay away from pit ****.
Official Aspie member

ANOUNCEMENT: Weird misspellings or words that make no sense? there was a good chance this was sent from my Droid 2 phone.
Quote by SinisterStrieth
.. You are the man.

RIP Dime RIP Michael Jackson