#1
What program of X-Edit goes with the RP 1000, it doesn't say it on the website unless I missed it. Is it the same as the RP 500?
#3
I don't know it says firmware for RP 500, would I be damaging my Rp1000 by using this?
#5
Quote by 311ZOSOVHJH
oh, so it doesn't give you an option for the 1000?

hum....well, i could jump on the site and look but it will be a few hours


It's been a few hours alright.
#6
you should've read page 3 of the RP1000 manual.

You can use the current version of X-Edit on their website.

nice bump btw. month old thread.
Can we erase the past?
To allow our dreams to forever last?

Gear:

Mesa Boogie Mini Rec 25
Mesa Boogie Rectifier 2x12 cab

Jackson DK2, DK2M, DKMGT, SLAT3-7, DK1
#7
Quote by signedinbloodnz
you should've read page 3 of the RP1000 manual.

You can use the current version of X-Edit on their website.

nice bump btw. month old thread.


He put that it would be a few hours and yet a month and 10 days later he had not put anything. I'm forgetful worse than that so don't worry about it. By the way, a guy on another board said that he contacted Digitech and they said that he should NOT use the X-Edit versions for other RP units because they weren't working out with the RP1000. I don't know how true that is. I went to the website and notice that when you go to the download section of the RP1000 they don't provide an X-Edit download like they do for their other units so I would wait a bit.
Last edited by mannydingo at Feb 23, 2009,