My Palomino V50's reverb has stopped working. I already took out the reverb pan to check for any wire breakage and to make sure the springs were ok. It looked fine, there were no breaks anywhere. There is no reverb sound whatso ever even with the reverb cranked. There is a considerable amount of hum when the reverb is turned up though, it sounds like the kind of hum you get from single coils. Help me, I'm stumped.
Well the reverb is a relatively simple circuit. I'd check the solder points off of the reverb pot. Also, double check the wires on the tank. The wire may not have a broken connection, it just may be a bad connection. One more thing to check is where the (usually) RCA cables plug into the tank and onto the board. Make sure all of these are solid.