#1
I'm wiring a stereo for a buddy kinda half assin a surround sound with what he's got.

I want to know what OHM load Im putting on the receiver and if it's safe, haha..

I have one receiver 50 Watts X 50 Watts Stereo each side is going to a box with an 8' driver, 1 inch horn driver and a Tweeter. Then I came out of the right speakers hot and the left speakers ground off the crossover and went to the sub. Sub is rated at four OHM's the 8 en closers are around eight watts or so.

So Is this a good way to do this or should I come right off the amp itself?

Any help would be appreciative I run PA gear I don't deal in home stereo's only and never odd numbers of speakers..
Mail Goes here.

Musician for 14 years. Been inactive on UG since 2007. My have times changed. It's good to be back.