#1
Hey guys
I was spraying the edge (black) of a burst, but the can start spitting a bit.... so it became speckled. What's the best way to fix this? I'm think of sanding the paint off and starting it all over.
Idea's?
#2
are u using lacquer ? spray like 5 coats of ur first color w colored lacquer and then ur 2nd color like 2 coats that way if u mess up on a burst u just sand the burst down and try again and try puttin the cans in warm water
Last edited by savage94 at Feb 25, 2009,
#3
Quote by savage94
are u using lacquer ? spray like 5 coats of ur first color w colored lacquer and then ur 2nd color like 2 coats that way if u mess up on a burst u just sand the burst down and try again and try puttin the cans in warm water


Yes I'm using colored lacquer. That black is the only part that is actual spray can paint, the colored portions (red) is the actual wood itself having been stained and sealed.
I guess I'll just sand the black back.
#5
Hold the can at an angle and i suggest getting one of those handles that clip on to the can so your finger doesn't hit the nozzle causing it to be speckled.