#1
well i just put 12's on my guitar with a licensed floyd and its set up fine but the actions too low and causing fret buzz. . . how do i raise it?

like detailed instructions would be really helpfull.
Equipment:
PRS SE custom Cherryburst
dean razorback V (green/black) currently on ebay
Digitech Death metal pedal [wanting to sell - £15]
Zoom G1X [wanting to sell - £25]
Line6 UX1 (with metal shop add on)
#2
Turn the two allen key bits that hold the bridge in

EDIT:

Top left and right on this pic
Last edited by sam b at Mar 24, 2009,
#4
Quote by sam b
Turn the two allen key bits that hold the bridge in

EDIT:

Top left and right on this pic


cheers !
Equipment:
PRS SE custom Cherryburst
dean razorback V (green/black) currently on ebay
Digitech Death metal pedal [wanting to sell - £15]
Zoom G1X [wanting to sell - £25]
Line6 UX1 (with metal shop add on)
#5
Only do it a bit at a time, ie. 1/4 turn on one, then 1/4 turn on the other.. and dont do it to too far, or the bridge'll obviously fall out
#6
Also try putting a little bit of chapstick on the posts where it comes in contact with the Floyd. It prevents flat spots rubbing on the Floyd's knife edges. Old trade secret with guitar techs haha
Endorsed by Dean Guitars 07-10
2003 Gibson Flying V w/ Moon Inlay
2006 Fender All-American Partscaster
SVK ELP-C500 Custom

1964 Fender Vibro Champ
1989 Peavey VTM60

[thread="1166208"]Gibsons Historic Designs[/thread]