#1
I just got two new Humbuckers and both only have two wires.
#1 neck pick-up has a BARE and a WHITE wire and both are covered in red Tubing.
#2 Bridge Pick-up has a BARE and a WHITE wire both covered in black tubing.

My setup is 1vol 1 tone and 3 way switch.

So to be sure how to install these, would the two bare wires go together and the two white on each side of the three-way switch?

Anyone know this???
#4
I don't have anything to get pics, i explained it perfect, someone should understand it.
#5
The white wires go to the switch, and solder the bare wires to the back of the volume pot.
YA GOTTA HIT IT ON THE ONE
pics of gear updated on profile 11/16/09
#6
Quote by XxxSDMFxxX
I don't have anything to get pics, i explained it perfect, someone should understand it.

You don't even understand, and you can see them
Actually called Mark!

Quote by TNfootballfan62
People with a duck for their avatar always give good advice.

...it's a seagull

Quote by Dave_Mc
i wanna see a clip of a recto buying some groceries.


stuffmycatswatchontv.tumblr.com