#1
Sorry if there is already something on this but I need the help of GB&C again.

Just to double check on what parts I have and if I missed anything

Pick guard blank
Neck Pickup
Bridge Pickup
Stop tail piece
Tune-o-matic bridge
Shielded guitar circuit wire, 4 conductor
Straight 3 way toggle switch
500k ohm pot
500k ohm push pull pot
.047uf ceramic disk tone caps
Mono out put jack
26 gauge guitar hook up wire
Strap buttons
Knobs
Toggle surround black les paul

Am I missing anything or do I have it all?

Also will the shielded guitar circuit wire, 4 conductor wire and 4 conductor pickups be able to go i and out of phase?
#3
Quote by MetalGuitarest
i don' tknow if you listed every single part you have but i noticed..

Strings
the main guitar..aha j/k

umm all i can think of atm


I just bought a full neck, and already have a body
#4
Strap locks. they come in very handy.
Also, some parts don't come with the screws.
Also, your pickups, do they have a pickup ring with it?
..I was watching my death.
#5
Quote by timbit2006
Strap locks. they come in very handy.
Also, some parts don't come with the screws.
Also, your pickups, do they have a pickup ring with it?

hmmm no Il add pick up rings
#6
Also, what about the rear control cavity covers? Make sure your pickguard blank has enough of it's blankyness to fulfill the needs of those control cavity covers.
..I was watching my death.
#7
What type of guitar is it? If it has a pickguard, then you probably don't need a control cavity or pickup rings (although some people add them just for aesthetics).
Member of the official GB&C "Who to Listen to" list
Quote by handbanana
wiliscool is just plain dumb
#8
what I do is get a picture of a guitar and look at all the parts on a guitar to see if anythings missing.

You are missing the nut and tuners