#2
Thanks, man... I'll ask them

I thought about a taper reamer... but, these Stew Mac ones are specially prepared for guitar, therefore I know they're the right ones for the job. Not only that, but they have a pilot, so it will be dead centred... unlike the ones I did with a normal drill bit

So, the Stew Mac ones are the right ones for me. Bargain price, too. So thanks, I will contact them
#3
i think you want the third one on the list
That’s how we’ll know. This is not a test, oh no
This is cardiac arrest


Of a world too proud to admit our mistakes
We're crashing into the ground as all fall from grace
#5
yup

Quote by EJD
.
Now, the tuners and bushings I'm drilling for are standard vintage Strat spec - that is, standard 11/32. 8.6mm bushings.



(from stewmac)
2062 .340" (8.64mm) diameter
That’s how we’ll know. This is not a test, oh no
This is cardiac arrest


Of a world too proud to admit our mistakes
We're crashing into the ground as all fall from grace