#1
Ok i havent even thought about airsoft for the past like 3 years, but while rummaging around in my attic, i found the disassembled remains of an HFC Bullpup 230. It has all its parts, but I cant for the life of me put it back together.

Ok so here are the pics...



The problem is the plunger housing (not identified, and not the correct name but whatever) wont line up with the two pegs in the cocking handle. It will move the plunger fine, and it will fire dry fine. But since the plunger housing doesnt move, there is no way for the magazine to get to the hopping unit. The problem is circled in green below.



I've tried resting the housing in the small notch to the lower left of the unit, but then the cocking handle's pegs dont line up and there is a large gap in the outside of the gun (where the cocking handle is visible).


I'm stuck, can anyone help meh?
Quote by justinrobbins7
*unzipppp* "Deal with this, wench."



Quote by Mazzakazza
Ug Knows 1000% More About Scrotal Sacs Than Real Doctors.
Hm Let Me Investigate. You Has The Painful Scroties? You Has Aids.
Next Plz.
#3
Don't understand. So the cylinder is not reaching the hop up?
breaking hearts
&
breaking guitars
#6
Quote by Kevy Absolution
Don't understand. So the cylinder is not reaching the hop up?


it IS, but the narrow end of the cylinder is blocking the clip from entering the gun
Quote by justinrobbins7
*unzipppp* "Deal with this, wench."



Quote by Mazzakazza
Ug Knows 1000% More About Scrotal Sacs Than Real Doctors.
Hm Let Me Investigate. You Has The Painful Scroties? You Has Aids.
Next Plz.