#1
I just changed the strings on my ibanez xiphos. how do i adjust the bridge to drop c? because the strings are a little bit too low and cause buzz. how do i raise its action? do i do anything else?

thanks in advance

shpunt
My Rig
------------------
Schecter Damien 6 (mod with 81/85 emg)
Ibanez Xiphos
Peavey Vypyr Tube 120 <3
Digitech RP250 (for Sale)
#2
Take a look at the Floyd Rose Setup sticky at the top of the page. There should be 2 large pegs on the 2 corners of the floyd rose. Those are for adjusting the action.

Make sure the bridge is level, as in parallel with the guitar's body. You'll have to adjust the spring tension to get it just right.
Quote by Perp8tualMotion
Thank you, Red Comet, for restoring a bit of my faith in human kind.
#3
What gauge strings did you put on?
Quote by bendystraw
what's pron?


EDIT: i googled it, you guys are gross.


a2m/gape/murder/suicide/farrakhan/braziliancakefarts/bugera
#5
if you get a thicker guage but lower tuning, i think there will be a good bit less adjusting to do, except you might want to tighten the springs a little and raise the action just a tad
-LTD Alexi 600
-LTD MH-100 QM
-Schecter Omen 6
-B-52 AT-112
Quote by My Father
So is this guitar Mexican made or human made? Wait, shit, that was really racist wasn't it?


My shitty covers: http://www.youtube.com/simpleben09