#1
Ok, so I'm putting a push pull in my strat. Could some please number the parts in the photo of the pot to match the numbers in the diagram? And since it will be wired lefty, I know point 1 would be switched to the other lug, but would point 4 be switched to be above point 1, or would it stay where it is?


#2
Ok, so I'm putting a push pull in my strat. Could some please number the parts in the photo of the pot to match the numbers in the diagram? And since it will be wired lefty, I know point 1 would be switched to the other lug, but would point 4 be switched to be above point 1, or would it stay where it is?

[IMG]http://img203.imageshack.us/img203/3949/diagram.jpg
[IMG]http://www.guitarnucleus.com/gnstore/elec/GN0286EL-500_meas.jpgThe left column of lugs on the switch works exactly the same as the right. Doesn't matter which column you use. Flip the lower picture upside down and it looks just like the drawing. Use the lug in the row closest to the lug on the volume control for convenience. Use the lug in the middle row, same column for the other connection.

If you're wiring lefty, you MUST use a linear pot. Audio taper will be far too abrupt at the low volume settings. If you have to use audio taper, you might want to wire it righty.
Meadows
Quote by Jackal58
I release my inner liberal every morning when I take a shit.
Quote by SK8RDUDE411
I wont be like those jerks who dedicate their beliefs to logic and reaosn.