#1
Hey UG.

EDIT: Ohms question, please scroll down


I've settled on my head (as you can see in my sig), but I'm unsure about the cab.
I've found a Randall R212CX on ebay, for a pretty damn good price, (It's on £50 at the moment, 20 hours to go).
I was wondering, is this a decent cab? It goes for £250 new, and has Celestion 80's in there.

If not, what other cab would you recommend, for maybe £150ish? But much rather go cheaper (willing to go 2nd hand).

Thanks.
Wait.



Roger Waters - 12th May!
Last edited by LezPaulEpiphone at Oct 4, 2009,
#2
It's a decent cab for the price. I wouldn't pay over 150 for it though.
MARSHALL JVM 210H
PEAVEY JSX
KRANK 412
MESA 412
FENDER STRATS
DIMARZIO
CELESTION
#3
^ thanks.

One more question, as the cab has 2 4ohm (stereo) and 8ohm (mono) inputs, and the head has 1x 16ohm, 2 8ohm and 2 4ohm outputs, I would run the 8ohm to the 8ohm on the cab, or the 4 to the 4?
And what's the difference between stereo and mono?
Wait.



Roger Waters - 12th May!
#5
Quote by LezPaulEpiphone
^ thanks.

One more question, as the cab has 2 4ohm (stereo) and 8ohm (mono) inputs, and the head has 1x 16ohm, 2 8ohm and 2 4ohm outputs, I would run the 8ohm to the 8ohm on the cab, or the 4 to the 4?
And what's the difference between stereo and mono?
You only use the stereo jacks if you are running two amps at the same time.

You are running in mono, so match the impedance. (8 ohm amp out into 8 ohm cab in)
MARSHALL JVM 210H
PEAVEY JSX
KRANK 412
MESA 412
FENDER STRATS
DIMARZIO
CELESTION
#6
Quote by Van Noord
You only use the stereo jacks if you are running two amps at the same time.

You are running in mono, so match the impedance. (8 ohm amp out into 8 ohm cab in)


Thank you man
Wait.



Roger Waters - 12th May!