#1
I'm putting together a pickguard with a Haum and a single, and I want to be able to select between the two, so I found a little on/on switch with 6ix polepieces on the bottom like this

| |
| |
| |

I understand that I probably solder the pickup wires to the outer poles, but I need to be sure. And where does the hot wire to the volume control go?
Quote by Meths
I respect and value your opinion.

Just kidding. You're a fucking retard.



Quote by Pr0gNut
You want to strap a bunch of used mattresses to the walls?

Why not just roll around naked in medical waste while you're at it?

Quote by the_perdestrian
medical waste isn't free on craigslist
#3
Two volumes: hot wire from pickup goes to volume, then outer post of switch.
One volume: hot wire to volume goes on the same side of the switch as pickup hot, but in the middle.
"I don't give a f*** if you boo, just boo in key"-Jimi Hendrix

SS

Gear:
Mesa Single Rectifier Solo head 50
Some crappy old cab
Vox Satchurator
Frontman 15G
Epiphone G-400
#5
Quote by madmike17
Two volumes: hot wire from pickup goes to volume, then outer post of switch.
One volume: hot wire to volume goes on the same side of the switch as pickup hot, but in the middle.



Alright Thanks. I wired it up and it works
And I'm just using 1 volume
Quote by Meths
I respect and value your opinion.

Just kidding. You're a fucking retard.



Quote by Pr0gNut
You want to strap a bunch of used mattresses to the walls?

Why not just roll around naked in medical waste while you're at it?

Quote by the_perdestrian
medical waste isn't free on craigslist