#1
Well I've been noticing that there really isn't much difference when my TS-9 is active and off.

Right now I'm just using it to drive the tubes more so the level is all the way, gain and tone nothing.

I hardly notice a difference. Is there any mods I can do that will drive my tubes more for my TS-9 and make it clearer?
Guitars:
Ibanez UV777P
Ibanez RGD2127FX
Ibanez RG3120TW
Ibanez RGD7321
Ibanez RG6003FM
Ibanez SA160
Jackson Slatxmg3-7
Amps:
Baron Custom Amps K88
Rivera Knucklehead TRE
Fryette Sig: X
Randall RM4 /w Modded modules
Cabs:
Mesa 4x12
Bogner 4x12
Peavey 4x12(K85s)
#3
are you using batteries? or power supply?

Battery may be dead, power supply may be inadequate.
#4
Tone should be set high.
A metal band?
Gear:
A Guitar with an LFR > Korg Pitchblack > Behringer EQ > Hardwire CM-2 Overdrive Boss SD-1 > Hardwire CR-7 Chorus>
Orange Tiny Terror >
LzR Engineering 212 cab

My other amp can run Crysis
#5
I'm using the P/S

And are you sure the tone should be set to high?

I'm just looking to tighten up my gain a little.
Guitars:
Ibanez UV777P
Ibanez RGD2127FX
Ibanez RG3120TW
Ibanez RGD7321
Ibanez RG6003FM
Ibanez SA160
Jackson Slatxmg3-7
Amps:
Baron Custom Amps K88
Rivera Knucklehead TRE
Fryette Sig: X
Randall RM4 /w Modded modules
Cabs:
Mesa 4x12
Bogner 4x12
Peavey 4x12(K85s)
#7
you need to turn the gain up at least a little bit otherwise the pedal won't put out much. the tone should come up a bit as well because it will muddy up your sound that low. leave the volume.
#8
Thanks guys, I feel dumb now
Guitars:
Ibanez UV777P
Ibanez RGD2127FX
Ibanez RG3120TW
Ibanez RGD7321
Ibanez RG6003FM
Ibanez SA160
Jackson Slatxmg3-7
Amps:
Baron Custom Amps K88
Rivera Knucklehead TRE
Fryette Sig: X
Randall RM4 /w Modded modules
Cabs:
Mesa 4x12
Bogner 4x12
Peavey 4x12(K85s)