#1


So I bought the 2 SPDT switchs that i need to wire up my 515o footswitch that I'm building, but I dont know where to wire them on the connectors. Each switch has three wiring points, and from what ive gathered, I have to wire a ground to two of them, and a hot signal to each one.

if a SPDT has three connectors, where do I make the connections on each switch?
1981 Gibson Les Paul Custom (Black Beauty)
1980 Marshall JMP 2204
#3
The SPDT as 3 connecters each. It joins the middle (common) to either the top or bottom connecter depending on what position the switch is in. The sleeve of the jack (ground) should go to one end of each switch, and the tip and ring to the middle of a switch each.
EDIT: You'll need a stereo jack and a stereo cable.
Last edited by littlephil at Dec 6, 2009,
#4
Sweet!

That makes sense.

Hot signals (Tip and Ring) to the center lugs, and the Ground to one of the outsides, I take that it dosent matter which one?
1981 Gibson Les Paul Custom (Black Beauty)
1980 Marshall JMP 2204