#1
I figured I'd just put the install of my FloydUpgrades in GG&A

Well here it is. All finished installing.



I have to admit it is a big upgrade compared what was in there. The noiseless springs actually have a lot more tension on them so I was able to take out one the silver spring that was in there. But i put heavier gauge strings on so it had to be put back :/. O well.

The big brass block was a major upgrade. Sounds so much better and there is a lot more sustain. (Look how little the old one is .



The floyd block is great for palm muting or recording since it won't go out of tune at all when pushed down on the back.

Here's what it was all put in.

Guitars:
Ibanez UV777P
Ibanez RGD2127FX
Ibanez RG3120TW
Ibanez RGD7321
Ibanez RG6003FM
Ibanez SA160
Jackson Slatxmg3-7
Amps:
Baron Custom Amps K88
Rivera Knucklehead TRE
Fryette Sig: X
Randall RM4 /w Modded modules
Cabs:
Mesa 4x12
Bogner 4x12
Peavey 4x12(K85s)
#4
Haha thanks guys. It was a little complicated to do since after you put the block in you have to reintonate your guitar, but it's well worth it!

By the way, in the first picture you can see some felt on the brass block. If it's not there the block seems to rattle on the blocker so it's kind of needed if you're going to do this mod.
Guitars:
Ibanez UV777P
Ibanez RGD2127FX
Ibanez RG3120TW
Ibanez RGD7321
Ibanez RG6003FM
Ibanez SA160
Jackson Slatxmg3-7
Amps:
Baron Custom Amps K88
Rivera Knucklehead TRE
Fryette Sig: X
Randall RM4 /w Modded modules
Cabs:
Mesa 4x12
Bogner 4x12
Peavey 4x12(K85s)
#6
thx
Guitars:
Ibanez UV777P
Ibanez RGD2127FX
Ibanez RG3120TW
Ibanez RGD7321
Ibanez RG6003FM
Ibanez SA160
Jackson Slatxmg3-7
Amps:
Baron Custom Amps K88
Rivera Knucklehead TRE
Fryette Sig: X
Randall RM4 /w Modded modules
Cabs:
Mesa 4x12
Bogner 4x12
Peavey 4x12(K85s)