#1
hello.....im new here and new with rebuilding a gutiar so this is the problem

so i bought a used body and neck from a local forum here in the philippines

the neck joint is slanted do i need to use some special screw or plate?

PICS kinda crappy



thanks in advance
#3
I know it is mounted at a angle, but at the angled portion, is it flat across? if so, any plate will do man.

Just call me Bobby
Member of the official GB&C "Who to Listen to" list
Quote by mikeyElite
you build guitars worthy of sexual favors

Quote by Invader Jim
if this party gets any livelier a funeral is gonna break out.
#5
Quote by metalwarrior40
I know it is mounted at a angle, but at the angled portion, is it flat across? if so, any plate will do man.


how about the length of the screw?
#6
You can most like use those yes, just counter ream the holes so they fit in (ferrules)
As far as screw length, your going to have to measure that for yourself.
Just call me Bobby
Member of the official GB&C "Who to Listen to" list
Quote by mikeyElite
you build guitars worthy of sexual favors

Quote by Invader Jim
if this party gets any livelier a funeral is gonna break out.
#8
ok....i went to a music store bought some screw and neck plates and tied to fit and it won fit the screw for the thicker portions fit with asmall gap between the plate and screwhead.....but for the thinner part theres a gap almost 4mm long......can i use wood screws from hardware stores?