#1
ok so I have some tuning pegs i bought from allparts, but they dont tell me how big of a hole i need to cut. my only clues: the diagram on the website (with no measurement units) and a picture of the product (as I cannot give you the ones in my hand)

the diagram:


link to the product online (if this is illegal let me know):
http://www.allparts.com/Gotoh-6-in-line-Mini-Keys-Chrome-p/tk-7760-010.htm

any help would be fantastic!

PS: just incase the link is against the rules, if you go to allparts it is product key tk-7760
"Would you tell Picasso to sell his guitars?" - Jack Black

Quote by Lt. Shinysides

my dick is generally better than yours, and is more pleasing to look at and hold.
your dick understands and accepts this, and is willing to just move on.
#2
The O with a slash through it means diameter. And those drawings are almost always in millimeters. So its a 10mm hole you need.
Quote by Stiffy Maximus
i smoke some weed and get naked. thats the way to write a good song.
#3
thanks! ill start up the drilling first thing in the morning!
"Would you tell Picasso to sell his guitars?" - Jack Black

Quote by Lt. Shinysides

my dick is generally better than yours, and is more pleasing to look at and hold.
your dick understands and accepts this, and is willing to just move on.
#4
test in on scrap wood first! dont just go drilling holes in your guitar
im sure hes right but just to make sure itsalways safer