#1
So I know the Cab is a 16 ohm cab. So I put the selector on 16 ohms on the 5150II head, right? Also, if I were to purchase another 1960 cab, what would I run the head on? Finally, I want to buy a THD hotplate as I cannot crank the amp when I am at my house. What ohm rating?
#3
If you run two cabs in parallel it's half the impedance (if you use the same). So using the 16 ohm inputs on both would give you an 8 ohm load at the amp.
Gilchrist custom
Yamaha SBG500
Telecasters
Randall RM100 & RM20
Marshall JTM45 clone
Marshall JCM900 4102 (modded)
Marshall 18W clone
Fender 5F1 Champ clone
Atomic Amplifire
Marshall 1960A
Boss GT-100


Cathbard Amplification
My band