Yup, that one except you want an audio taper, not linear.
Rhodes Gemini
Fryette Ultra Lead
Peavey 6505
THD Flexi 50

Gibson R0 Prototype
EBMM JP13 Rosewood
Fender CS Mary Kaye


(512) Audio Engineering - Custom Pedal Builds, Mods and Repairs
Oh dear, no. Use desoldering braid or a desolder bulb from radioshack.

The braid might be easier to use. You place it on the old joint, heat it with the iron, and solder gets sucked off the joint and moves to the braid.

The bulb is nice too, you heat up the joint, and use the little rubber bulb to suck out the solder as the joint is hot.
Why do I feel like this is going to end in tragedy?
Everyone is entitled to an opinion.

Feel free to express yours so I can make an informed judgement about how stupid you are.