#1
I'm thinking I could possibly use this feature as an attenuator?

My amp is currently set up as usual (even though it's a combo you can change it slightly) so the head is using the normal output jack to connect to speaker.

If I changed it from the usual output to the Slave/DI output could I then use the Slave/DI level knob as an attenuator?

Cheers guys.


HELLO!

#2
^ Unless you go into a solid state power amp with it, no.

The DI is just preamp level. You can't drive a cab with it.

Also, your output transformer will melt if you try that with no load on the amp.
Everyone is entitled to an opinion.

Feel free to express yours so I can make an informed judgement about how stupid you are.