So...I'm not quite sure how to best set up my NS-2 pedal based on the equipment Ive been running. If somebody could advise me on the best/proper set up based on what I have in my chain I would greatly appreciate it. So basically I have my guitar going straight into my Valveking. I have the send on the effects loop of my amp going to the input on the NS-2 and the output on the NS-2 going into the return on the effects loop of my amp. Is this correct? Is this the best placement to reduce the most noise? I also have a delay pedal that I am going to put into my chain once I get an adapter for it. How would I set it up then? The input/output/send/return on this pedal is confusing me. Wishing my new amp had a built in gate like my flextone II. Thanks!