#1
I already one question tonite but this is a seperate issue i just thought of. Bugera 6260s have a switch allowing them to change their ohm load. If you pull two tubes, do you treat these numbers as halved, or will the amp compensate for lost power? Again, thank you.
#2
your amp will not compensate automatically....again, not familiar with the Bugeras.

So if you are used to running at 120 watts at 16 ohms and you pull two tubes to run at 60 watts then you need to set selector on 8 ohms and 'ideally' run into a cab with a 8 ohm load.