#2
look in the specs sectio of the manuals for each of your pedals add up the milliamps (mA) if it`s less than 500mA then you will be ok
#3
That adaptor supports 500mA maximum. I would believe so.
Gear
Fender Hotrod Deville 2x12
Fender MIM Strat | Epi Dot 335
Fulltone '69 mkii | Boss OD-1
'95 RAT2 | '78 IC Big Muff | DL4
#7
Quote by Art13
and again, what theoretically with 5 pedals? fish n chips, badm onkey, hardwire tl2, little big muff and korg pitchblack.

fine or better go with
http://www.thomann.de/gb/digitech_ps0920_netzteil.htm
or maybe even
http://www.thomann.de/gb/harley_benton_powerplant.htm


F'n C - ~ 20mA
BM - ~17mA
TL2 - ~25mA
LBM - ? Don't know. The NYC BMP is ~5mA so it's probably close to that.
Pitch Black - 0.07mA off/ 8mA on/ 35 mA tuning. Korg says it's this though: 500 mA - 1.2 Amp

I wouldn't use the one in the first link. I believe that outputs 9v AC not DC as it's used for the Whammy which uses AC.

Not sure about the second link. Not much info there. May be just a glorified daisy chain.

I think you are probably going to want a decent power supply with that many pedals although people run that many a more with the One Spots and Godlyke daisy chains and are happy. I personally would just get a Pedal Power 2 and be done with it.
#8
pedal power would be far too expensive, any that specific thomann adapter users? how is the noise(i have red that with many pedals there could be noise)?