#1
How much would it cost to :

1. Get a single fret replaced
2. Get my input jack resoldered
3. Get my bridge area routed to fit a Floyd Rose
4. Have a Dimebucker put into the neck position

on my Hagstrom XL-2, which is totally stock
#2
2 and 4 should be DIY jobs. Frets are a bit more tricky, but not really too difficult.

The routing is something that someone with no experience could fcuk up. You would want to get someone clever to do it.

Cost? Don't have a clue.
Marshall amplifiers are the truest purveyors of rock and roll known to man.

"And give a man an amplifier and a synthesizer, and he doesn't become whoever, you know. He doesn't become us."

Holy crap, check this out!
#3
dont know about the fret job. agreed with seemeel about 2 and 4 but the floyd runs around
400 for labor and an OFR but thats for a local guy so dont know if it helps
(\__/)
(='.'=)
(")_(")98% of teenagers in America are currently bringing sexy back. Put this in your signature if you are one of the 2% where sexy never left.