#1
I've got a guitar sitting in front of me, two humbucker one vol one tone.

The three way toggle is a boxy looking one with three posts and a few around the sides used as grounds I believe.

There's two wires coming from each of the pickups. One white and ground on the bridge, and one red and ground on the neck.

Can anyone help me with where the two wires are supposed to connect? I haven't wired up pups like dis.
#2
http://www.seymourduncan.com/images/support/schematics/2h_1v_1t_3w.jpg

Ignore the white and red wires in this diagram.
The white wire from your bridge pickup will equate to the black bridge wire in the diagram.
Your red neck wire will be the black neck wire in this diagram.
Epiphone Les Paul goldtop (EMG 81/85)
Epiphone Les Paul Custom
Fender Telecaster MIM
Epiphone SG Special
Jay Turser JT200 Serpent (GFS Crunchy Rails/Crunchy Pat)
Dean V-Coustic
Ovation Celebrity
Bugera 333-212
Crate Blue Voodoo 120H
#3
Thanks. I wasn't too sure if it'd be the same or what. My toggle is a little different, but you think it'd be the same?
#4
Should be. Post pictures.

One terminal by itself is invariably the ground, and usually the three posts together are in-out-in. As in, you would wire the center post through the pots to the jack, and the outside posts to the pickups.
Epiphone Les Paul goldtop (EMG 81/85)
Epiphone Les Paul Custom
Fender Telecaster MIM
Epiphone SG Special
Jay Turser JT200 Serpent (GFS Crunchy Rails/Crunchy Pat)
Dean V-Coustic
Ovation Celebrity
Bugera 333-212
Crate Blue Voodoo 120H
#5
I can't post pics right now, I'm on my cell. But I tried it, then saw the capicitor was in the wrong position after a failure, then tried it again and got nothing.