#1
I want to coil tap the EMG HZ H4 in the bridge of my ltd ex260, as I don't like the sound of them as they are now (And the coil tap on my Schecter Omen Extreme 7 sounds great).

I have found the two wires that need to be soldered to a switch to be grounded. I want to know if I can solder them to the middle position of the 3 way pup selector and have it so the selector goes bridgehum-coiltapped bridge-neck?


If I can't do that, Ill just buy a push pull pot. Even with that, I wouldn't know 100% where to solder each wire, are there any good instructions on the net you could link me?

Cheers
#2
Here's the diagram for the push/pull switching version: http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_1v_1t_3w_1pp

Edit: the diagram above has the wire colors that correspond to seymour duncans. Go here: http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=color_codes to translate. The EMG's have the same colors as fenders.
Last edited by matt154 at Mar 26, 2011,