#1
So I recently bought a used Epiphone Sg Jr. And the pots were broken. I replaced them with Gibson pots but they don't go through the holes to put on the knobs. Now I read that I just had to drill the holes bigger.

How would I go around doing this? Or is there another alternative?
Quote by LPDave
and my mom then told me to masturbate more.

Quote by Toastbot

Big burly men grunting without shirts on pretty much summed up my childhood.

Quote by The Leader
Has anyone really been far even as decided to use even go want to do more look like?
#3
Quote by Ippon
You could probably get away with using a small screwdriver wrapped with 200 to 400 grit sandpaper and using that to enlarge the hole. Go slow and check often.

Good Luck!



It worked perfectly. Thanks a lot!
Quote by LPDave
and my mom then told me to masturbate more.

Quote by Toastbot

Big burly men grunting without shirts on pretty much summed up my childhood.

Quote by The Leader
Has anyone really been far even as decided to use even go want to do more look like?