#1
Both of my amps have FX loops, but since I run them in stereo at the same time, I can't really use both FX loops at the same time (to my knowledge...?).

So I had an idea for a (hopefully) simple pedal. It will basically switch between 2 signal paths, like so:
Off: Guitar - [pedal] - amps
On: Guitar - [pedal] - other pedals - amps.
So basically a footswitch that makes my pedalboard footswitchable/bypassable.......??

I don't know anything about making pedals, but I'm experienced with soldering and can follow directions. It sounds like it should be a very simple build, but I just don't know where to begin. Any help/links would be greatly appreciated.
Guitars:
-Agile Interceptor Pro 7-string
-PRS SE Standard

Amps:
-Bugera 6262 2x12 combo
-B-52 AT-100

Pedals (rarely used):
-Digitech Whammy
-BBE Green Screamer OD
-Morley Bad Horsie 2 wah

Home made cabinets and cables
Last edited by J☺e at May 3, 2011,
#3
YES! Thanks. I'll get started on that.
Guitars:
-Agile Interceptor Pro 7-string
-PRS SE Standard

Amps:
-Bugera 6262 2x12 combo
-B-52 AT-100

Pedals (rarely used):
-Digitech Whammy
-BBE Green Screamer OD
-Morley Bad Horsie 2 wah

Home made cabinets and cables