#1
Hey I have an '08 Gibson Explorer and from what I have read many others have faced this problem, The EMG ZW solder-less set that I have laying around doesn't seem to work in the 1 Master tone and 2 individual Vol. situation. I have gotten it to the point where i am using the black and green together in the O section of the bus and everything is in the position the directions said; the pickups seem really smooth (bad kind) not the aggressive overdrive they are known for. To make it worse the Tone works but the volumes don't do anything, just stay on full. If I move things around I can get the volume pots to only turn it down to low volume not off.

Anyone have success over this, I'm pretty PO'd

P.S. i have used multiple new batteries so don't worry about mentioning that
Gear:
Gibson '61 SG (57 Classics)
Ibanez RG4EXFM1 (TB-6)
Gibson '08 Explorer (500T)
Soldano Avenger 100
No Name 4X12 w/ Texas Heat+V12
I Want More Stuff
#2
Hey, nvm, this can be cancelled or something, I found the one obscure mistake I made!
Gear:
Gibson '61 SG (57 Classics)
Ibanez RG4EXFM1 (TB-6)
Gibson '08 Explorer (500T)
Soldano Avenger 100
No Name 4X12 w/ Texas Heat+V12
I Want More Stuff
#3
Quote by penguinguy34
Hey, nvm, this can be cancelled or something, I found the one obscure mistake I made!

glad you got it sorted out
Member of the Schecter Hellraisers
Gear:
Esp Ltd KH-603, Schecter c-1+ and Epiphone Les Pauls
Carvin amps, Sperzel Trim-Lok, Emg active pickups only, Tonepros bridges.