#1
Hey everyone, I recently upgraded my amp to a Marshall mg100hdfx Half stack, which I purchased used BUT still in amazing condition from craigslist. Now everything sounds perfect on it, but when I plug in my Dunlop Crybaby Original pedal, this high frequency hum and buzz and just a mess of sounds occurs, even when the pedal is on its "off" mode. There's no way this sound can be normal either because I've seen tons of videos with the marshall mg100hdfx and wah pedals and there is no unwanted noise. Anyone know what could be the issue? Anything is very much appreciated....
#3
I recently upgraded my amp to a Marshall mg100hdfx Half stack, QUOTE]

Hate to see what you upgraded from.
Ibanez SIR27
Pod HD500x

RIP:
Mesa Boogie Roadster 2x12 combo
Cmatmods analog chorus, phaser, tremoglo, signa drive, butah, and deeelay
walrus Audio Descent
#4
Quote by Griffin Effects
Are you sure you didn't mix up the input and outputs of the wah?

Nope.. the wah still works but it has a lot of terrible sounding buzzing and humming noises