I want to try plugging a 4x12 into the twin as the main speaker, can I safely do this without damaging the amp? In the manual it says that a total of 4 ohm speaker impedance should be used to avoid damage for the external speaker, though it doesn't say anything about the main. My 4x12 is 8 ohm.
Last edited by danleary at Jun 10, 2011,
*Looking for picture of my amp*
We've dressed up in our best...

...and are prepared to go down like gentlemen.

Quote by bogg808
The PBT is for those too TGP for the rest of UG.