#1
Hi all!

Looking at buying the supa-charger to power my board. It has the 110v/220v switch, will this let me use it in Australia, I thought our mains power was 240v?

Cheers!
Fender USA Standard Stratocaster
PRS SE Custom
Fender Hot Rod Deluxe
Tonerider British Distortion
Tonerider American Overdrive
Boss DD7
Big Muff Pi with Tone Wicker
Treble Booster.
#3
Yes, it will be fine.

Btw, were you aware that Australia is officially 230V now?
Gilchrist custom
Yamaha SBG500
Telecasters
Randall RM100 & RM20
Marshall JTM45 clone
Marshall JCM900 4102 (modded)
Marshall 18W clone
Fender 5F1 Champ clone
Atomic Amplifire
Marshall 1960A
Boss GT-100


Cathbard Amplification
My band
#4
Happy days!

I was reading a lot of old forums that said 240v, had no idea we were now 230v! But cheers for that!
Fender USA Standard Stratocaster
PRS SE Custom
Fender Hot Rod Deluxe
Tonerider British Distortion
Tonerider American Overdrive
Boss DD7
Big Muff Pi with Tone Wicker
Treble Booster.
#5
It's actually 230V +10% -6%. If you measure the voltage at your power point it will almost certainly read 240V because very few (if any) places have actually converted. New transformers will be 230V but anything installed prior to 2000 will still be 240V.
Rule of thumb, in domestic appliances (and pretty much anything else) 10% is zero. A 10% variation in voltage, resistance, capacitance, inductance, whatever will make no difference. Electronic devices aren't that accurate, where accuracy is required in a circuit some sort of regulator will be sorting that out but even then it's unlikely they will care about a measley 10%. An old Electronics prof of mine always used to say "10 + 1 = 10."
Gilchrist custom
Yamaha SBG500
Telecasters
Randall RM100 & RM20
Marshall JTM45 clone
Marshall JCM900 4102 (modded)
Marshall 18W clone
Fender 5F1 Champ clone
Atomic Amplifire
Marshall 1960A
Boss GT-100


Cathbard Amplification
My band