If I were to buy a pickgaurd that isn't prewired, how would I atttach my own electronics to it? With glue?
um there is a nut that goes on the other side.
Jumping on dat gear sig train.
PRS Hollowbody II / BKP Warpigs
Strandberg OS6T / BKP Aftermath
Strandberg OS7 / Lace Poopsticks
Skervesen Raptor 7FF / BKP Warpigs
Skervesen Raptor 6 NTB / BKP Juggernauts
Hapas Sludge 7 FF / Hapas Leviathan
Anderson Baritom / Motorcity Nuke BKP Sinner Anderson H2+
Warmoth Baritone / BKP Piledriver
Ibanez Rg2120x / BKP Nailbomb

Blackstar ID:Core Beam
pots have a nut on top and bottom, pull off the knob (pull upward, can be tough to get off)
pickups generally have little bolts. an output jack generally has a couple of screws.
you will have to resolder the ground wire running from the trem claw to the volume pot, and probably the output jack wires because you may have to cut them to run them to the jack