#1
I was wondering if someone knows where I could get a diagram for this. I'm putting a Dimarzio Crunch Lab and an Air Norton S into my Strat, keeping the middle single coil so its essentially an H-S-H wiring type. I want two Push/Pull tone controls which i'm going to be using to coil tap the Bridge and Neck pickups and a volume control. I've taken out the pickup selector and i'm going to be using 3 DPDT switches instead so i can turn them on, off, or get them out of phase. Haven't been able to find a wiring diagram for this.
#3
Quote by ticktockboom
I was wondering if someone knows where I could get a diagram for this. I'm putting a Dimarzio Crunch Lab and an Air Norton S into my Strat, keeping the middle single coil so its essentially an H-S-H wiring type. I want two Push/Pull tone controls which i'm going to be using to coil tap the Bridge and Neck pickups and a volume control. I've taken out the pickup selector and i'm going to be using 3 DPDT switches instead so i can turn them on, off, or get them out of phase. Haven't been able to find a wiring diagram for this.

First you'll need this for the following diagrams (In order to convert Seymour Duncan wire colors to Dimarzio):
http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=color_codes

Coil Splitting:
http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=coil_splitting

Coil Splitting with Phase switching:
http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=phase_switch_coil_split_hb

Phase switching:
http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=phase_switching_for_hb

I didn't see a 3 on/off switches diagram for HSH but this is the same thing:
http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=3s_1v_1t_3on-offswitches

So with all that, you should be able to wire 1vol, 2 tones, and 3 on/off switches. The 2 tone controls will be push-pulls for coil splitting.

I think in order to get phase switching and on/off for each pickup you'll need to separate the two functions. I could be wrong...I've never messed with phase switching. It seems that in order to accomplish all of that on each of the 3 switches, you would need 3 way 3PDT switches, which I'm not sure I've ever seen, or maybe I have and don't remember. Seems logical, sense you would need 3 options. 1) On (phase normal), 2) Off, 3)On (phase reversed).

If you come across 3 way 3PDT toggle switches then you should be in business, but otherwise you'll probably have to dedicate another switch for phase reversal. Maybe a push-pull on the volume pot.

Hope that helps
Maybe someone with more knowledge on the subject will chime in though.