#1
I got the drilled the hole, and thats fine. I got the pickup, and its installed. I'm on the last step. I'm putting the jack into the hole, and before this I thought about this too" How am I going to tighten the nut?" There is no way to tighten it from the outside of the guitar. I can't reach inside to do it by hand, and No tool I find can do it. Any suggestions on how to tighten the danm nut holding the jack inplace?
Gear

Guitars
Ibanez ART 300
Squier Strat
Godin 12 string Antique cedarburst
Ibanez RGD 320

Amps
Peavey Vypyr Tube 60W
Peavey Solo 15 W
Fender 10 W

Effects
Dunlop GCB - 95 Crybaby wah
Boss DD-7 Digital Delay
Boss MT-2 Distortion
#2
turn it?

what type of guitar is it and what type of pickup did you install?
Prs se Holcomb is the answer
Last edited by AcousticMirror at Dec 14, 2011,
#3
Art&Lutherie antique cedarburst.. its a 12 string. I'm putting in a fishman Neodo2. I've already cut the end off it, because it came with a male end. since i'm putting it into the hole, that i put my previous pickup in(itsounded like shit so i took it out) I'm converting it to a female end..
Gear

Guitars
Ibanez ART 300
Squier Strat
Godin 12 string Antique cedarburst
Ibanez RGD 320

Amps
Peavey Vypyr Tube 60W
Peavey Solo 15 W
Fender 10 W

Effects
Dunlop GCB - 95 Crybaby wah
Boss DD-7 Digital Delay
Boss MT-2 Distortion
#4
Couldn't you remove the strings stick your hand in the soundhole and hold the nut while you tighten it and once it's snug you shouldn't really need a tool after that, no?
GEAR:
Epiphone Les Paul Studio Deluxe
ESP LTD EX-360
Peavey VYPYR 30W

"There's nothing constant in the universe.
All ebb and flow, and every shape that's born,
bears in it's womb, the seeds of change".