#1
I was going to get the PRS Tremolo with the rubber on the end that they put on the American made ones, but I have an SE. Will it work on that tremolo or do I have to stick with the all metal one?
2010 Fender American Standard Stratocaster
2011 PRS SE Santana limited edition of 25
2007 Ibanez SZ520QM-VCB
2009 Washburn Renegade WM23
Vox 20W Valvetronix

#2
Those are two different trems, the US model is alot thicker.
Last edited by sstony at Dec 17, 2011,
#3
It probably won't be a direct drop-in. SEs are metric, USs are imperial. Holes wont line up, etc etc.
#4
Do you know where you can find a rubber tip to put on the end of the SE bar? It's no big deal really, just think it looks a bit better for some reason
2010 Fender American Standard Stratocaster
2011 PRS SE Santana limited edition of 25
2007 Ibanez SZ520QM-VCB
2009 Washburn Renegade WM23
Vox 20W Valvetronix

#5
Also, could I put the Phase II locking tuners on the SE or is that a different fit as well?
2010 Fender American Standard Stratocaster
2011 PRS SE Santana limited edition of 25
2007 Ibanez SZ520QM-VCB
2009 Washburn Renegade WM23
Vox 20W Valvetronix

#6
Quote by john.pratt1321
Also, could I put the Phase II locking tuners on the SE or is that a different fit as well?

I´ll see if I can get some measurements on those when I go to work on monday but I´m pretty sure they wont fit.
#7
Thanks
2010 Fender American Standard Stratocaster
2011 PRS SE Santana limited edition of 25
2007 Ibanez SZ520QM-VCB
2009 Washburn Renegade WM23
Vox 20W Valvetronix

#8
I'm not sure. The tuner peg holes in the SE are probably the metric-standard 10mm. US standard is 3/8 inches.