#1
Can I install this with a hand drill (without any fear of getting the angle too far off!) instead of a pillar drill? http://www.stewmac.com/shop/Bridges,_tailpieces/Electric_guitar,_non-trem_bridges/Schaller_Non-Tremolo_Roller_Bridge.html

Its 3 screws so Im scared I will misplace one meaning the entire bridge will be off (BAD)!

-Thanks for the help!
#2
If it's a flat topped guitar you could get one of the drilling jigs in this article:

http://www.rockler.com/blog/index.cfm?mode=entry&entry=7F491F43-1372-6771-F6E0FA7D26277FE0

I honestly wouldn't be too concerned. Just take your time and have someone spot you while you pre-drill out the holes for the screws.

That bridge has individually adjustable saddles so you should not have any issues.
Last edited by earthwormjim at Jan 11, 2012,